Tromix Shark Brake for MKA 1919

Tromix Shark Brake for MKA 1919

Firearm not included.

Installation Instructions
1.        Make sure your gun is unloaded.
2.        Slide brake over barrel until it bottoms out and apply a piece of tape around the barrel at the base of the brake.
3.       Rough up the end of the barrel above the tape line with 80 grit sand paper.
4.       Apply loctite #620 bearing mount to the inside of the brake and to the barrel above the tape line.
5.       Slide the brake in position and make sure to “clock” the two round holes upward.
6.       Allow to dry for 20 minutes.
7.       Reach through the brake with a Tromix extended choke tube wrench and remove the choke.
8.       Run a cleaning patch down the barrel and out the muzzle to clean out any excess loctite.
9.       Allow to dry 24 hours and be sure to reinstall the choke before firing.